P77.S/K36-C series is an inverted mounting phase shifter, designed for 36mm optical aperture measuring equipment with a trave; of up to 20μm. The load capacity for horizontal, vertical and inverted mounting is 7kg, 1kg and 5kg respectively. The P77.S/K36-C series piezoelectric phase shifter is relatively small, only 80*80*35mm with a central aperture of 36mm.
Characteristics
|
|
|
|
|
|
|
|
Appearance ![]() |
Moving Part ![]() |
Direct-driving ![]() |
40nm Step Curve ![]() |
Application case-Phase shift ![]() |
Displacement Measuring ![]() |
Technical data | |||
Models |
P77.S36 |
Units |
|
Active axes |
Z |
|
|
Travel range(0~120V) |
14 |
μm±10% |
|
Max.travel range(0~150V) |
17.5 |
μm±10% |
|
Aperture |
Φ36 |
mm |
|
Height |
35 |
mm |
|
Resolution |
0.5/0.2 |
nm |
|
Pitch/Yaw/Roll |
<10 |
μrad |
|
Unloaded resonant frequency |
300 |
Hz±20% |
|
Unloaded Step time |
2 |
ms±20% |
|
Push/pull force |
100/50 | N | |
Load capacity |
Horizontal |
7 |
kg |
Vertical |
1 | ||
Inverted |
5 | ||
Electrical capacitance |
3.6 |
μF±20% |
|
Material |
Aluminum, steel |
|
|
Mass |
565 |
g±5% |
|
Operating temperature |
-20~80 |
℃ |
|
Control |
1~3 channel |
|
|
Connector |
LEMO |
|
|
Cable length |
1.5 |
m±10mm |
Note: Max driving voltage could be -20V~150V, Recommended voltage 0~120V for long-term operation to extend lifetime. Technical data are measured by CoreMorrow E00/E01 series piezo controller.
Technical data are measured by CoreMorrow E00/E01 series piezo controller.
Mounting Method |
Horizontal Mounting |
Vertical Mounting |
Inverted Mounting |
Definition |
Place the PZT platform horizontally for installation, with the moving surface located above the PZT platform and parallel to the horizontal plane.
PS: Default direction for carrying capacity in the parameter table
|
Place and install the PZT platform vertically, with the moving surface parallel to the direction of gravity
|
Place the PZT platform horizontally, but the moving surface is located below the PZT platform |
Diagram |
![]() |
![]() |
![]() |
Note |
When the mounting method is selected as vertical mounting, pay attention to the outlet port |
|
|
|